Using The Molding Genie
The Molding Genie can be used to assist in the installation of moldings, trim
work, doors, windows and other construction materials that normally would require two people.
The device is reusable and may be used as a single device, as a pair, or more. It can also be used to mount a laser level to assist in the layout and installation of your project.
Take a Closer Look
Instructions
Place the adhesive strips in the indentations on the rear of The Molding Genie (TMG). Peel the backing from the strips to reveal the adhesive. TMG is now ready to adhere to a clean, dry surface.
Use the small Micro-Adjust Knob at the bottom of TMG to fine tune the desired height of the work to be installed.
Tighten the center Locking Knob to lock TMG in place. Install your work using appropriate fasteners or tools.
Locate the desired height of the work to be installed (crown molding, cabinets, doors, etc.) and adhere TMG by pressing it to the surface. Slightly loosen the center Locking Knob to allow for vertical and horizontal movement of TMG.
Adjust the Angle Lock Plate to the desired angle of the work to be installed. Lock the Angle Lock Plate using the two knobs on either side of TMG.
Holding TMG firmly, slowly pull one exposed tab of the adhesive strips down until it releases from the surface, then repeat with the other strip. The adhesive strips will stretch significantly before releasing from the wall.